(1) the hatch machine should be installed on the concrete floor, the ground should be keep smooth, hatching machine when installation should be slightly forward (some) backward tilt, so that the discharge when cleaning, in front of the machine to hold space for 2 ~ 3 m.
(2) the temperature of the incubator should be kept in the 20 ~ 27 ℃, the temperature is higher than 27 ℃ or below 20 ℃, the installation of air-conditioning equipment or other measures shall be taken into account. Humidity shall be maintained at about 50%. Indoor to have good leak air condition, hatching machine machine (especially the young) to use in waste gas piped to the outside. Hatch room always cleaning, washing, painting and disinfection. Using egg turning 80 ° Angle is the key to improve the hatchability. Hatch egg turning can interval 8 ~ 12 hours, 3 days before the young to give cheeper after-hours stop egg turning.
Hatch young embryo lung function, has been formed in the late need enough oxygen, so the mulch and breeder eggs to have certain space and increase the number of ventilation.
(3) to electric machine after the installation of commissioning, check whether the normal temperature and humidity control system, and according to the request to temperature. Also check over temperature, low temperature alarm system for XXX, active time egg turning system is normal, stay running 1 ~ 2 days, everything is all right rear can officially into the hatch.
(4) applications to look at any time the machine door had put thermometer temperature, if there is any abnormal phenomenon to check the temperature control system, in time to eliminate the fault.
(5) with the increase of the embryonic age should be appropriate to open air inlet and outlet, the late should be opened entirely, in order to ensure the normal development of the embryo's need for oxygen, but early should not open too big, lest heat slower, waste of electricity.
(6) meets the request note of egg turning Angle, timing is accurate, it is best to make all the hatch machine eggs in the same direction, in order to govern. Every turn eggs at a time should be recorded.
(7) to pay attention to humidify unit can't without water tank (plate), experience the gauze of components and the water box to change water frequently, gauze to wash after reshipment after contaminated with dirt. For hatching machine wet without active control device, should time water dish heating water and according to the request of different incubation period of humidity, adjust the number of water dish, in order to ensure the request of the embryonic development of humidity.
(8) per hatch after a batch of a batch or the young, want to undertake to the hatching machine or give cheeper thoroughly washed and disinfected. Then check that the mechanical parts with and without loosening, touch, check reducer in lubricating oil, and clear the dust and fluff on the electrical equipment and other dirt. Electric test run for a period of time, adjusted the temperature and humidity last in hatch next batch.